Question 1

How much does an HVAC checkup typically cost in Columbus, Ohio?

Accepted Answer

In Columbus, Ohio, most homeowners can expect to pay between $75 and $150 for a single HVAC checkup, depending on the company, how detailed the tune-up is, and whether the visit covers both heating and cooling equipment. Basic inspections fall near the lower end of the range, while more comprehensive system tune-ups fall toward the higher end.

Question 2

What is usually included in an HVAC checkup?

Accepted Answer

A typical HVAC checkup includes inspecting and changing the air filter, checking thermostat operation, tightening electrical connections, verifying refrigerant levels, inspecting the blower motor and belts, checking visible ductwork and vents, and performing basic safety and efficiency tests. For gas furnaces, a checkup may also include burner inspection and carbon monoxide testing.

Question 3

How often should I schedule an HVAC checkup in Columbus?

Accepted Answer

Most Columbus homeowners benefit from scheduling at least one HVAC checkup per year, typically in spring or fall. Many choose two visits per year: one before cooling season to service the air conditioner and one before heating season to service the furnace or heat pump. Regular maintenance helps reduce breakdowns and extend equipment life.

Question 4

Can an HVAC checkup help lower my energy bills?

Accepted Answer

Yes. A well-maintained HVAC system runs more efficiently and does not have to work as hard to keep your home comfortable. Cleaning coils and filters, correcting airflow issues, and catching failing parts early can reduce energy use and lower monthly utility bills, especially during peak heating and cooling months.

Heating Tune Up and Furnace Repair

Heating Tune Up Checklist

Remove & Clean Burners

Remove & Clean Pilot Burner & Orifice

Test Hot Surface Igniter

Test All Safety Limits

Clean flame sensor

Adjust Gas Pressure

Clean Drain Trap

Remove and clean flue pipe

Disposable Rags

Clean Return Drop

Clean Blower Area & Filter Rack

Remove Blower Assembly When Necessary (i.e. visual heat exchanger inspection, to clean it, etc…)

Clear Out Pressure Switch Ports

Test Pressure Switch Terminals

Check and repair any loose terminals/wires

Record Amp Draw on blower and inducer assembly

Take total amp draw of the system at line connection and record

Take & Record Temperature Rise

Recommend media filter replacement if it is older than one year